Installing a Fibreglass Roofing System in the Winter
There are three main issues when installing fibreglass roofing system outside during the winter months, cold weather, wet weather and shorter days. But with the correct information and a little bit of planning, you can still get the job done.
Apart from wrapping up and braving the elements, follow our simple checklist to get the most from your fibreglass materials.
Our Top Tips for installing Fibreglass Roofing Systems Work in Winter
- Always check the local weather forecast, it is a good idea to have an app on your phone that you rely on for this.
- Check the temperature. Do not start fibreglassing if the temperature is below 5°C as it will not cure. Use the catalyst addition chart to calculate the percentage of resin that should be used.
- During the shorter winter days, avoid fibreglass or topcoating a roof after 2-3pm. The heat from the sun helps the curing process, it is unlikely that it will cure overnight after the sun sets. This will affect the finish of the topcoat and debris can stick to the surface of resin which will have to be removed.
- Check the temperature of the boards, resin and topcoat before laying the fibreglass. The resin should be left in a warm room the night before using it if the ambient temperature is below 10°C. Care should be taken to ensure that the resin does not freeze.
- If it starts raining, stop working immediately and cover the roof with a visqueen sheet.
- If you have the deck laid and are unable to laminate it, then coat the decking with catalysed resin to seal it from moisture. Ensure that all exposed edges are covered. Use a visqueen sheet to cover edges and uncoated boards. before
- If you are unable to laminate over a prepared deck, then coat the decking with catalysed resin and cover any exposed edges. This will seal the deck and prevent moisture uptake until the laminate can be applied. Always cover the edges of the roof and uncoated boards with a polyethylene sheet.
- Always ensure the deck or substrate to be laid onto is completely dry before laying the laminate. Sweep off any excess water and mop up the excess with dry cloths before allowing the roof to dry naturally. Wiping the surface with acetone can speed up this process.
- Resin will be thicker in cold weather and will require extra effort to work it into the glass and more resin may be required.
- Do not start to lay a roof if rain is forecasted.